FRANCO BELGE Boutiques de Feu Ubinas Instrucciones De Montaje página 25

"Ubinas" - ref. 634 10 47/634 10 48
Forbidden
1
2
3
1 - Flue
- Stainless steel
2
funnel
- The pipe casing
3
must equal at least
40 mm
Figure 6 - Connection to flue
-
Check prorer operation of the moving parts (flap,
valve, door, etc...) to ensure they are not blocked by
installation materials (plaster, cement, etc...).
2.6. Preparing the flue pipe
Figure 7
If the existing chimney has a draught regulating system,
it will have to be removed or sealed in the open position.
a - Close the base of the throat of the chimney with a
sheet-metal plate or masterboard which will have been
drilled at the appropriate place and on which will be
fitted a small collar of diameter 180 mm.
b - Tightly fit the flue connection (X-581) from the stove
to the small collar.
c - If the floor of the hearth is rough, place a metal plate
to ease the setting of the insert fire in the chimney.
634 10 47 only
The fans must be plugged on 230 V.
Technical manual "646"
1
4
5
6
4 - Funnel-shape
fireproof material
- Sealed flange
5
6 - The pipe does not
exceed the flange and
the casing equals at
least 40 mm
X
581
1 - Funnel-shape fireproof material
a & c - Sheet-metal plate
- Lenght X - 581 pipe
b
Figure 7 - Preparing the flue
2.7. Recommendations for installation
and insulation
For all the various installation configurations, the hearth
plate must be made from incombustible material. If the
walls of the chimney are made from combustible
material, the installation should be carried out as
follows (figure 8, page 8).
In the case of use of incombustible materials, we
recommend that an air space be left around the
appliance.
Installation instructions
1
7