Initial Operation; Manual Time Setting - DAY 73362 Manual De Instrucciones

Initial operation

Obstacles can severely impair the range of
transmission.
Protect the transmitter against any direct
sunlight penetration.
Open the battery compartment on the rear
of the outdoor remote sensor and insert
the batteries. Pay attention to the correct
polarity. Close the battery compartment
Open the battery compartment on the rear
of the receiver and insert the batteries. Pay
attention to the correct polarity. Close the
battery compartment.
When you insert the batteries, all the icons
on the LCD display will brie� y light up for
3 seconds, you will hear a beep, and the
device will detect indoor temperature and
humidity.
The receiver will now start to make a
connection to the outdoor remote sensor.
This operation takes about 3 minutes and
is displayed by a � ashing reception RF
antenna symbol in the "OUTDOOR" display
area on the receiver.
Once the receiver has established a
connection to the outdoor remote sensor, it
will then enter clock mode.

Manual time setting

Press and hold the MODE button for 2
seconds. The Year display 2012 starts to
� ash. Now use the UP and DOWN buttons
to set the correct year.
Press MODE to con� rm your setting. The
Month display starts to � ash. Now use the
UP and DOWN buttons to set the correct
month.
Press MODE to con� rm your setting. The
Date display starts to � ash. Now use the UP
and DOWN buttons to set the correct date.
Press MODE to con� rm your setting. The
language selection for the Weekday displays
starts to � ash. Now use the UP and DOWN
buttons to select a language.
Press MODE to con� rm your setting. The
Time zones start to � ash. Now use the UP
and DOWN buttons to set a correct time
zone (-12 to +12).
Press MODE to con� rm your setting. The
12/24 hour mode display starts to � ash.
Now use the UP and DOWN buttons to set
the correct 12/24 hour mode.
Press MODE to con� rm your setting. The
Hour display starts to � ash. Now use the UP
and DOWN buttons to set the correct hour.
Press MODE to con� rm your setting. The
Minute display starts to � ash. Now use the
UP and DOWN buttons to set the correct
minute.
Press MODE to con� rm your setting and to
end the setting procedures. The clock mode
will be displayed.
Note
After 7 seconds without pressing any
button, the clock switches automatically
from Set Mode to Normal Time Mode.
There are 7 languages for Weekday: English,
German, Italian, French, Spanish, Dutch and
Danish
GB
23