Publicidad
Idiomas disponibles
Idiomas disponibles
The Laser Beams Flash
E
When in self-leveling mode, the laser is designed to self-level
up to an average of 4° in all directions. If the laser is tilted
so much that the internal mechanism cannot level itself, the
laser beams will flash indicating that the tilt range has been
exceeded.
THE FLASHING BEAMS CREATED BY THE LASER ARE
NOT LEVEL OR PLUMB AND SHOULD NOT BE USED
FOR DETERMINING OR MARKING LEVEL OR PLUMB. Try
repositioning the laser on a more level surface.
The Laser Beams Will Not Stop Moving
The laser is a precision instrument. Therefore, if it is not
positioned on a stable (and motionless) surface, the laser will
continue to try to find level. If the beams will not stop moving,
try placing the laser on a more stable surface. Also, try to make
sure that the surface is relatively flat and level, so that the laser
is stable.
Specifications
Light Source
Laser Wavelength
Laser Power
Working Range
Accuracy
Power Source
Operating Temperature
Storage Temperature
Environmental
12
Service and Repairs
Note: Disassembling the laser level will void all warranties on
the product.
To assure product SAFETY and RELIABILITY, repairs,
maintenance and adjustment should be performed by
authorized service centers. Service or maintenance performed
by unqualified personnel may result in a risk of injury.
To locate your nearest Stanley service center, go to
http://www.D
DW03601
Laser diodes
630 – 680 nm visible
≤3.2 mW CLASS 2 LASER PRODUCT
33' (10m)
±0.16" @ 33' (±4 mm @ 10m)
4 AA (1.5V) size batteries (6V DC)
14°F to 104°F (-10°C to 40°C)
-5°F to 140°F (-20°C to 60°C)
Water & Dust Resistant to IP54
WALT.com.
E
DW03601CG
510 – 530 nm visible
50' (15m)
Publicidad
