Configuring A Panel For The Steering Position Where The Panel Is Placed - Vetus BOW PRO B Serie Instrucciones De Instalación

6 .8 Configuring a panel for the steering position
where the panel is placed
Carry out the following actions on EACH panel in the order indi-
cated:
N.B. The panel must be in the OFF position (if the panel is NOT in the
OFF position, first press the On / Off button once to switch the panel
to the OFF position.
1
10 seconds
1 Place the panel in configuration mode
• Press and hold the On / Off button for 10 seconds.
2
2 Push the joystick to the right.
5
OR
Helm station
1 2 3 4 1
5 Select the helm station where the panel is sited by pushing the joystick to the left or the right and then
releasing it. The colour and flashing of the LED indicates the number of the helm station.
With a bow and stern thruster panel, together at the same helm
station, the helm station number entered must be the same .
vetus® Installation instructions BOW PRO Series Thruster: BOWB150 - BOWB180 - BOWB210
dididididididid ( . . . . . . )
6 seconds
3
3 Keep the joystick in this position and press
the On/Off button.
Helm station
2
3 4
n
ote
2
3
1
ON/OFF
BPPPA
4 seconds
During the first 6 seconds, the buzzer will continuously signal a didi-
didididi ..... (. . . .). Keep pressing the On / Off button. After 10 seconds
the buzzer sounds the signal dididididah (. . . - -). Now the panel is in
configuration mode.
4
didahdi
( . − . )
4 Release the joystick after the signal didahdi
( . – . ) is given.
1 BLUE, ashing
2 RED, ashing
3 BLUE, ashing
RED, quick ashing
4 BLUE and RED,
simultaneously ashing
Settings are retained even if the supply voltage is switched
ENGLISH
ON/OFF
BPPJA
dididididah ( . . . . − )
Con guration mode
6
1 x
6 Press the On/Off button once
to confirm the setting.
n
ote
off!
020809.04
31