Getting Started - Jays x-Seven Manual Del Usuario

EN English

Getting started

Power on/off and pairing
To power on, press and hold the on/off button for 2s, the LED will
blink in blue three times.
To pair, press and hold the on/off button for 5s, the LED will blink in
blue and red. Go to Bluetooth® settings on your device and select
"Jays x-Seven Wireless". The blinking LED will turn off upon a
successful connection followed by a short audio beep. After
successful connection, the blue LED will flash every 5 seconds.
To power off, press and hold the on/off button for 5s, the LED will
blink in red.
Reconnecting
Next time you power on, the headphones will automatically try to
reconnect to the most recently used device. If not found, or if you
manually disconnect through your device, pairing mode will
automatically be initiated again. To force pairing mode, press and
hold the on/off button for 5s from off state.
Using the audio cable
Connect the audio cable to the audio jack and your device. The LED
will blink in red once as Bluetooth ® pairing with your device
disconnects automatically.
Battery status and charging
When paired with iOS devices, the battery status of the headphones
is shown in the upper right corner on the iOS device.
Charge by connecting the included USB cable to the USB jack and
connect it to any certified USB power output. A full 100% charge will
take around 2-3 hours (depending on temperature and charger).
Charging is indicated by a solid red light on the charging LED, and a
full charge is indicated by a solid green light on the charging LED.
Troubleshooting
Problem pairing and connecting
• Make sure the headphones are not connected to another device.
• Disable and enable Bluetooth® on your device.
• Move the headphones closer to the device or alter their
positions to avoid Bluetooth interference.
• Verify no other wireless equipment interfere with your earphone
Bluetooth signal.
Problem with sound transmission
Move the streaming device to another position. Your body,
distance, different materials and other wireless equipment can
interfere with the wireless signal between your device and
earphone.
FAQ and quickstart guide
Visit jaysheadphones.com for more instructions and help on this
product.