Initial Operation; Switching On/Off; Mounting The Wheel - IVT AG-115S Manual De Instrucciones

side.
∙ Do not operate the tool near flammable materials.
∙
Do not place your hand near the rotating accessory.
∙ Do not leave the machine in operation while it is
unattended.
UNPACKING
When unpacking, check to make sure that all
components are included. Refer to the drawings on this
manual. If any parts are missing or broken, please call
IVT assistance center.

INITIAL OPERATION

Always use the correct supply voltage: the power supply
voltage must match the information quoted on the tool
identification plate.
MOUNTING THE PROTECTION DEVICES
Before any work on the machine itself, pull the mains
plug. When working with grinding and cutting wheels
(8), the movable guard (4) must be mounted.
Movable guard (4)
The coded protrusion (11) on the movable guard (4)
ensures that only a guard that fits the machine type can
be mounted.
∙ Loosen the locking screw (12) if necessary.
∙
Place the movable guard (4) with the coded
protrusion (11) in the coded groove on the spindle collar
[F1] and rotate to the required working position. [F2]
The closed side of the movable guard (4) must
always point toward the operator.
∙ Tighten the locking screw (12).
Auxiliary handle (6)
When working with the machine, the auxiliary handle (6)
must be mounted.
∙
Screw the auxiliary handle (6) into one of the thread
(10) on the machine.

MOUNTING THE WHEEL (8)

CAUTION! Before any work on the
machine itself, pull the mains plug.
Use only grinding tools whose allowable speed is at
least as high as the no-load speed of the machine.
Roughing and cutting wheels become very hot while
working; do not touch before they have cooled.
Mounting the grinding / cutting wheel (8)
Pay attention to the dimension of the wheel (8).
The internal diameter of the wheel must fit the inner
flange (7) without play. Do not use reducer pieces or
adapters. When using a cutting wheel (8), take care that
the direction of rotation arrow on the cutting wheel and
direction of rotation of the machine (direction of rotation
arrow on the machine head) point in the same direction.
∙ Lock the spindle by pressing the spindle locking
button (3) (only when the tool is at a standstill!).
∙
Unscrew the outer flange (9).
∙ Fit the cutting wheel (8) on the inner flange (7).
∙
Screw on the outer flange (9) and tighten with the
pin spanner (14). [F3]
Before switching on, check if the grinding wheel (8)
is properly mounted and can turn freely.
SWITCHING ON / OFF
(AG-115S) [F4]
Switching On
Slide the On / Off switch (5) forward without pressing.
Switching Off
Move back the On / Off switch (5).
(AG-125; AG-125G; AG-150H) [F5]
The machine is equipped with a lock-off button (1) to
avoid unintentional starting.
Switching On
To switch the machine on, push the lock-off button (1)
and press the On / Off switch (5).
Switching Off
Release the On / Off switch (5).
OPERATING INSTRUCTIONS
Grinding [F6]
The best results are achieved with an angle of 30° to 40°
for grinding. Move the machine back and forth with light
pressure. In this manner, the workpiece does not become
too hot, no discolouration occurs and no ridges are produced.
Under no circumstances should a cutting wheel be
used for roughing work.
Cutting [F7]
When cutting, do not press, tilt or oscillate. Work with
a moderate feed rate that is suited to the material to
be worked.
13
Instruction manual
EN