Technical Data - Yamato 95894 Manual De Instrucciones

Cod 95894
EQUIPMENT
1 pc. Wet and dry vacuum cleaner
1 pc. Instruction manual

TECHNICAL DATA

Modello TWIRLING
Power
Vacuum power
Inox tank
Sound power level
LwA
Sound pressure level
LpA
Weight
STANDARD USE
The machine is suitable for the suction of powder solids and liquids.
When using electric tools it is imperative to take the following basic safety precautions in order to
reduce the risk of electric shock, injury and fire. Read and take note of these instructions before you
use this tool.
GENERAL SAFETY REGULATION
• Read this manual carefully before operation to avoid the hazards such as electric shock, burn of
fire.
• Minimum fuse protection 10A
• Pay attention to the environment, do not expose the tool in rain or humid place. Keep work
area lit up. Don't use the tool in presence of inflammable liquid or gas.
• Pull the mains plug out of the socket when: the unit is not in use, before opening the unit, before
cleaning and maintenance.
• The work area must be kept clean to avoid danger
• Don't overload the tool. Operate only within the load level suggested.
• Always use a suitable tool. Do not use any tools that are too powerful or not powerful enough,
but above all do not use the machine for purposes and tasks other than the ones it has been
designed for.
• Never carry the tool by cord or yank it to disconnect from receptacle. Keep cord far from heat,
oil and sharp edges.
• Avoid hazardous positions. While working, it is necessary to adopt a safe position so that
balance is ensured. Pay attention to accidental falls while cleaning the stairs.
• Check the cable regularly and, if damaged, have it replaced by a qualified engineer. Check
that any extension leads are suitable and do not show any sign of damage.
• Always keep handles dry and clean from oil or grease.
• Disconnect tool when not in use, before serving and when changing accessories, such as bits.
• Avoid unintentional starting. Don't carry plugged-in tool with finger on switch. Be sure that the
switch is off when plugging in.
• Before further use of the tool, a guard or other part that is damaged should be carefully
checked to determine that it will operate properly and perform its intended function. Check for
alignment of moving parts, binding of moving parts, breakage of parts, mounting, any other
condition that may affect its operation. A guard or other part that that is damaged should be
properly repaired or replaced by an authorized service center unless otherwise indicated
elsewhere by dealer.
• Outdoor use extension cord. When tool is used outdoors, use only extension cords for that use
and so marked.
• For operational safety, do not remove any protection or bolts from their original position.
• Do not touch the moving parts of the machine or its accessories without previously unplugging
the machine electrical cable from the network.
cod. 95894
1,0/70 3POWER
W 1.000 x 3
20 Kpa
70 Lt
83 dB
73 dB
kg 15
5