Unpack The Beverage Center; Reverse Door Swing (Optional); Bottom View - Whirlpool WUB50X24HV Manual De Uso

Unpack the Beverage Center

Excessive Weight Hazard
Use two or more people to move and install
Beverage Center.
Failure to do so can result in back or other injury.
Remove the Packaging
• Remove tape and glue residue from surfaces before
turning on the Beverage Center. Rub a small amount of
liquid dish soap over the adhesive with your fingers.
Wipe with warm water and dry.
• Do not use sharp instruments, rubbing alcohol,
flammable fluids, or abrasive cleaners to remove tape or
glue. These products can damage the surface of your
Beverage Center. For more information, see "Beverage
Center Safety."
• Dispose of/recycle all packaging materials.
When Moving Your Beverage Center
Your Beverage Center is heavy. When moving the
Beverage Center for cleaning or service, be sure to
cover the floor with cardboard or hardboard to avoid
floor damage. Always pull the Beverage Center straight
out when moving it. Do not wiggle or "walk" the
Beverage Center when trying to move it, as floor
damage could occur. Having someone push against the
front top of the Beverage Center takes some weight off
the front leveling legs. This makes it easier to push the
unit on the rear rollers.
Clean Before Using
After you remove all of the package materials, clean the
inside of your Beverage Center before using it. See the
cleaning instructions in "Beverage Center Care".
Important information to know about glass
shelves and covers:
Do not clean glass shelves or covers with warm water
when they are cold. Shelves and covers may break if
exposed to sudden temperature changes or impact,
such as bumping.
Tempered glass is designed to shatter into many small,
pebble-size pieces. This is normal. Glass shelves and
covers are heavy. Use both hands when removing them
to avoid dropping.

Reverse Door Swing (optional)

Tools Needed:
Phillips screwdriver and an 8 mm wrench (or 5/16" in
wrench).
1. Unplug Beverage Center or disconnect power.
2. Using the screw driver, remove the screws from each
side of the top of the Beverage Center cabinet and set
aside.
NOTE: There are seven screws total. Do not discard.
3. Remove the top hinge and set aside.
4. Lift the door straight up and off
the bottom hinge.
5. Set door lying flat with gasket facing up.
Door should be placed on a debris free
surface such as cardboard or blanket to avoid scratches.
6. Remove the screws (B) fastening the black metal door
stopper (C) and re-attach it on the opposite side.

BOTTOM VIEW

7. Remove the screws from each side of the kickplate and
set aside.
5
B
C
A