Base Grille; Beverage Center Use; Normal Sounds; Using The Control - Whirlpool WUB50X24HV Manual De Uso

NOTE: Having someone push against the top of the
Beverage Center takes some weight off the leveling legs.
This makes it easier to adjust the leveling legs.
4. Open the door again to make sure that it closes as
easily as you like.
If not, tilt the Beverage Center slightly more to the rear
by turning both front leveling screws to the left.
It may take several more turns, and you should turn
both leveling legs the same amount.

Normal Sounds

Your new Beverage Center may make sounds that your old
one didn't make. Because the sounds are new to you, you
might be concerned about them. Most of the new sounds
are normal. Hard surfaces, such as the flooring and
surrounding structures, can make the sounds seem louder.
The following describes the kinds of sounds and what may
be making them.
• Your Beverage Center is designed to run more efficiently
to keep your food items at the desired temperatures and
to minimize energy usage. The high efficiency
compressor and fans may cause your Beverage Center
to run longer than your old one. You may also hear a
pulsating or high-pitched sound from the compressor or
fans adjusting to optimize performance.
• Rattling noises may come from the flow of refrigerant or
items stored inside the Beverage Center.
• As each cycle ends, you may hear a gurgling sound due
to the refrigerant flowing in your Beverage Center.
• You may hear water running into the drain pan when the
Beverage Center is defrosting.
• You may hear clicking sounds when the Beverage Center
starts or stops running.

BEVERAGE CENTER USE

Tools Needed: Phillips screwdriver
Remove the Base Grille
1. Open the Beverage Center door.
2. Using the screwdriver, remove the two screws.
3. Remove the base grille.
Replace the Base Grille
1. Open the Beverage Center door.
2. Position the base grille so that screw
holes align into place. Replace the two screws.
Tighten the screws.

Using the Control

The control panel is located on the middle separator
(mullion) of the Beverage Center. The control panel
has no mechanical parts or buttons.
Turning Control On/Off
The first time that the Beverage Center is plugged in, the
control will be in Off mode.
To turn ON the unit, press
To turn OFF the unit, press
Viewing Celsius Temperatures
Press the touch pad to toggle between displaying the
temperature in degrees Fahrenheit
and degrees Celsius.
The corresponding indicator will
illuminate.
Adjusting the Interior Light
Press touch pad to toggle between ON and OFF.
7

Base Grille

button for 3 seconds.
button for 3 seconds.