Publicidad
Step 10
Carefully turn your unit over onto its front edges. Unfold
å
the BACK (I) and lay it over your unit.
Make equal margins along all four edges of the BACK (I).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the BACK (I) to your unit using the NAILS (17).
å
NOTE: Be sure to tap NAILS into the holes that line up
å
over the UPPER SHELF (G).
These holes will be used for the
TIPPING RESTRAINT KITS.
Page 14
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
These holes must line up
over the UPPER SHELF (G).
I
www.sauder.com
Caution
17
NAIL
(35 used in this step)
414816
Publicidad
