geberit ECO 202 Instrucciones De Servicio página 24

EN
Pressing with Geberit pressing attachments
Prerequisites
• Pipe ends are deburred and clean
• Pipe and pressfitting have been fitted together in accordance with the piping system
installation manual
WARNING
Risk of injury caused by flying fragments if used incorrectly or if worn or damaged
pressing attachments are used
Only use the pressing attachments if they are in perfect working order (see the
basic safety notes)
Make sure that the diameter of the pressfitting matches the diameter of the
pressing attachment
Do not tilt the pressing attachment on the pressfitting
Clean away any dirt, chips or the like between the pressing attachment and the
pressfitting
If the pressing attachments have been used incorrectly, or in a way that does not
comply with their intended use, do not continue to use them and have them
examined by an authorised repair shop
Wear suitable protective equipment (protective goggles etc.)
Pressing attachments (pressing jaws, adapter jaws, pressing collars) are wearing
parts. Frequent pressing will cause the material to become worn; advanced stages of
wear will be indicated by incipient cracks. Pressing attachments that display this kind
of wear or are damaged in any other way may break, particularly if they are used
incorrectly (e.g. pressing a fitting that is too large, tilting, foreign bodies on the fitting)
or in a way that does not comply with their intended use.
WARNING
Danger of crushing when the pressing tool closes automatically
Do not hold any parts of your body or other objects in between the pressing jaws
and adapter jaws
Do not hold the pressing tool in the area of the pressing jaws or adapter jaws
CAUTION
Damage to the device caused by continuous operation
Allow the pressing tool to cool for at least 15 minutes after 30 minutes of
continuous operation
The procedure for pressing depends on the type of pressing attachment and is
described in detail in the user manual of the relevant system.
24
B972-003 © 06-2015
965.597.00.0 (02)