geberit ECO 202 Instrucciones De Servicio página 27

Fault
Red LED lights up
Pressing tool stops and no
LED lights up
Red and green LEDs flash
alternately
1) The addresses of authorised repair shops can be requested from the Geberit sales companies or found
at www.geberit.com
B972-003 © 06-2015
965.597.00.0 (02)
Cause
Pressing tool is overloaded.
Non-permissible pressing
systems were processed
Mains voltage is too low
Pressing tool is defective
Power failure
Maintenance interval has
been reached
Action
Release start button
Press unlocking button
Only process permissible
pressing systems
Repeat the pressing
operation
Check the mains voltage
Fully unreel the cable drum
of the extension cable
If using several extension
cables: reduce extension
After a power failure, press
unlocking button
Press the start button
If this is not successful,
send the pressing tool to a
repair shop for testing
Release start button
Press unlocking button:
roller drive moves to its
starting position
Examine the pressfitting for
tightness and repeat the
pressing operation if
necessary
Send the pressing tool to
an authorised repair shop
1)
for testing
EN
1)
27