DELAY (TIMER) BUTTON
•
When the unit is running, press this button to program a time when the unit will
automatically turn off. Use the / buttons to set the delay (in one-hour incre-
ments) until the unit will shut down. After a few seconds the display will return to
showing the current temperature.
•
If the unit is off and you want it to turn on in a certain amount of time, program it
in the same way as above.
•
Once the delay is programmed, the LED (i) will remain illuminated. To check the
program, simply press the DELAY button again. Pressing it again while the time is
shown on the display will cancel the timer.
•
To cancel program, press the DELAY button twice.
Note: Delay time can be set between the range of 1 - 24 hours. The unit must remain plugged
in for the timer to function properly.
REPLACING THE REMOTE CONTROLLER BATTERIES
1. Press gently on the tab located on the back side
of the remote control unit. Slide open the bat-
tery compartment cover.
2. Replace the batteries with two AAA 1.5v batter-
ies. Insert batteries while respecting the polari-
ty of the batteries (+ and - sides). Replace both
batteries at the same time. In order to avoid a
battery leak, never insert an old battery with a
fresh battery.
3. Gently close the battery compartment cover.
REMOTE CONTROLLER OPERATION NOTES
•
When using the remote control, aim the controller directly at the air conditioning
unit's iR receiver located on the control panel.
•
The remote control must have a clear line of sight to the control panel, and may
not work past 25 feet.
•
When the remote control will remain unused for long periods of time, please re-
move the batteries.
Infrared transmitter
–10–
AAA batteries
Close
Open
Battery compartment cover