Assembly; Operation - Vacmaster VQ1530SFDC Manual Del Usuario

GB
NOTE: A Phillips screwdriver is required.
1) Remove all the contents from inside of the vacuum cleaner container.
2) Attach the carry handle into the slots located on the top of the power head (Fig. 1).
3) Turn the container upside down and insert the feet with casters into the slots and apply
pressure until they click into place. Secure them with supplied screws (Fig. 2).
4) Your vacuum cleaner comes ready for dry vacuum cleaning with the cartridge filter pre-installed.
If the cartridge filter is not installed, refer to page 8.
5) Optionally, for improved dust filtration, fully fit the dust bag flange onto the inlet stub (Fig. 3).
6) For wet vacuuming, replace the cartridge filter with the foam filter supplied. Do not use a dust
bag when wet vacuuming. If the foam filter is not installed, refer to page 9.
7) Secure the power head back on the container, using the 2 side latches. Insert the locking end
of the hose into the suction port of the container (Fig. 4).
8) Choose the desired accessories and/or extension wands and push fit onto the hose nozzle.
8) Choose the desired accessories and/or extension wands and push fit onto the hose nozzle.
1. Switching On/Off
Connect the mains plug to a suitable a power outlet.
Position
I
O
II
2. Power Tool Take-Off Operation (Fig. 5)
WARNING:
off socket against the desired power tool before connecting to prevent overloading.
1) Connect the power cable of your power tool to the power take-off socket.
2) If applicable, connect the vacuum suction hose to the dust extractor connector on your tool with
the supplied adaptor.
3) Switch the vacuum cleaner to position II, as described in Switching ON/OFF. The moment you
switch on the power tool, the vacuum cleaner will also switch on. Once the electrical appliance
has been switched off, the vacuum cleaner switches off following a time lapse (around 5
second) to allow the suction tube to be emptied.

ASSEMBLY

OPERATION

Status
on
off
automatic synchronized start-up
Always check the maximum wattage compatibility of the power tool take
8