Environmental Protection; Product Description; Machine Components; Safety Signs - Stiga MP2 500 Li D48 Serie Manual De Instrucciones

1.7. ENVIRONMENTAL PROTECTION

• Scrupulously comply with local regulations for the disposal
of packaging, deteriorated parts or any elements with
a strong environmental impact; this waste must not be
disposed of as normal waste, it must be separated and
taken to specified waste disposal centres where the
material will be recycled.
• Scrupulously comply with local regulations for the disposal
of waste materials
• When the machine is withdrawn from service, do not dispose
of it in the environment, but take it to a waste disposal facility
in accordance with the local regulations in force.
Do not throw electrical equipment away with
domestic waste. According to the European
Directive 2012/19/EU on electrical and electronic
equipment waste and its implementation in
compliance with national standards, old electrical
equipment must be collected separately, for eco-
compatible recycling. If electrical equipment is
disposed of in dumps or in landfills, hazardous
substances can leak into the groundwater and
contaminate the food chain, damaging your health
and well-being. For further information on the
disposal of this product, contact your dealer or a
domestic waste collection service.
At the end of their working life, dispose of batteries
paying due attention to the environment. Batteries
contain material classified as hazardous for you
and the environment. They must be removed and
disposed of separately at a facility that accepts
lithium-ion batteries.
Separate waste collection of the products and
packaging used allows the materials to be recycled
and reused. Reuse of recycled materials help to
prevent environmental pollution and reduces the
demand for raw materials.

2. PRODUCT DESCRIPTION

This machine is pedestrian controlled lawnmower.
The machine is essentially composed of an motor which
drives a cutting means enclosed in a casing, equipped with
wheels and a handle.
The operator is able to operate the machine and use the main
controls, always staying behind the handle at a safe distance
from the rotating cutting means.
If the operator leaves the machine, the engine and cutting
means will stop within a few seconds.
Intended use and improper use
This machine is designed and built for cutting grass in gardens
and grassy areas.
Any other usage may be hazardous and harm persons and/
or damage things.
Examples of improper use may include, but are not limited to:
• transporting other people, children or animals on the
machine;
• being transported by the machine;
• using the machine to tow or push loads.
• operate the cutting device in non grassy areas;
• using the machine for collecting leaves or debris;
• using the machine to trim hedges, or for cutting vegetation
other than grass;
• use of the machine by more than one person.
IMPORTANT Improper use of the machine will invalidate the
warranty, relieve the Manufacturer from all liability, and the user
will consequently be liable for all and any damage or injury to
himself or others.
IMPORTANT The machine must be used by one operator.

2.1. MACHINE COMPONENTS

(Fig. 1)
A. Chassis
B. Engine
C. Cutting means
D. Rear discharge guard
E. Rear discharge chute (if available)
F. Side discharge chute (if provided)
G. Side discharge guard (if provided)
H. Grass catcher
I. Handle
J. Control lever
K. Drive lever (if provided):
L. Hatch for accessing the battery compartment
M. Safety key (Deactivation device)
N. Battery
O. Battery charger

2.2. SAFETY SIGNS

IMPORTANT Damaged or illegible labels must be replaced..
Order replacement decals from an authorised service centre.
3. ASSEMBLY
IMPORTANT Unpacking and assembly must be carried out
on a flat, solid surface with sufficient space to move the machine
and the packaging.
1. Unpacking (Fig. 2)
2. Assembling and adjusting the handle (Fig. 3)
3. Grass catcher assembly (Fig. 4)
EN - 3
WARNING:
Read the instructions before operating
the machine.
DANGER! Risk of thrown objects. Keep
all persons away from the work area
whilst working.
DANGER! Danger of cutting yourself.
Cutting means in motion. Do not put
hands or feet near or under the opening
of the cutting means.
BE CAREFUL when using the sharp
cutting device. Do not put hands or feet
near or under the opening of the cutting
means. The cutting means continues
to turn even after the motor has been
switched off. Remove the safety key
(deactivation device) before doing
maintenance.
Only for lawnmowers with combustion
motors.