Team kalorik TKG SIS 1001 Manual De Instrucciones página 13

Fax +32 2 359 95 50
examination and repair. Incorrect re-assembly can cause a risk of
electric shock when the iron or steam tank is used.
Fully unwind the main cord and supply hose before starting to
iron.
The power switch should always be put in position "0" before
plugging or unplugging the power cord from outlet.
Unplug the appliance and allow the iron and the water tank to
cool down before cleaning or storing them and for pressurized
steam iron station (depending on the model) before opening,
filling or emptying the water tank.
FOR PRESSURIZED STEAM IRONING STATION (DEPENDING
ON THE MODEL), NEVER OPEN THE CAP OF THE STEAM
TANK WHILE THE APPLIANCE IS CONNECTED TO THE
MAINS WALL SOCKET AND ESPECIALLY WHEN STEAM IS
BEING PRODUCED.
Please note: Should the symbol
surface, you need to be careful when handling the product. This
symbol means: CAUTION, this surface may get very hot during
use.
The symbol
temperature, however the other metallic or non-metallic surfaces
can also become very hot during use and it is therefore advisable
to always handle them with care and if possible with the help of
isothermal gloves or other thermal protection. In case of doubt
concerning the temperature of a certain surface it is always
preferable to protect oneself.
(*) Competent qualified service: after-sales department of the
producer or importer or any person who is qualified, approved and
competent to perform this kind of repairs in order to avoid all danger.
In case of need you should return the appliance to this service.
BEFORE THE FIRST USE
•
We recommend cleaning the iron before the first use as follows: fill the water tank, put the
temperature dial on position "LINEN" and the steam regulator on MAX and let the iron
heat for 10 minutes. When the temperature has been reached, take the iron from the
base, hold it vertically and keep the steam button pressed for 30 seconds, then wait 30
seconds and repeat this cycle twice.
•
Switch off the appliance (switch in position "0"), unplug it and let it cool down sufficiently,
then clean the soleplate with a damp cloth.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
is always put on the surface with the highest
13
Assembly page 13/64
be indicated on a certain
TKG SIS 1001 - 130827