Steam-Ironing - Team kalorik TKG SIS 1001 Manual De Instrucciones

Fax +32 2 359 95 50
•
Velvet and other textures that rapidly acquire shiny spots should be ironed in one direction
only (with the nap), applying only light pressure.
Always keep the iron moving.
•
Iron the reverse side of synthetic materials and silk, it is not advisable to use steam as this
may cause stains.
FILLING WITH WATER (FOR STEAM-IRONING)
1. Put the base on a stable surface.
2. Use the small grips of the water tank to take out the water tank. Open the cap and fill the
water tank with clear water up to its "Max" level. Do not fill beyond this maximum level! You
can use tap water, but we advise you to use distilled water.
3. Close the cap of the water tank.
4. Put the water tank back in the base correctly. Make sure to keep it upright in order to
avoid spilling water. Press the grips until the water tank is locked in place.
5. Never use vinegar, detergents or other chemical products.
FILLING THE WATER TANK DURING USE
As the water tank of this appliance is not under pressure, you can refill it during use. To do so,
switch off the appliance, unplug it and just proceed as described above in the "Filling with
water" section. When you have put the water tank back in place, plug the appliance in again,
switch it on and wait until the indicator lamp of the iron goes out. Then you can start ironing
again.

STEAM-IRONING

•
Fill the water tank with water and insert the mains plug into a wall socket.
•
As indicated on the temperature dial and in the table, steam ironing is only possible at
higher ironing temperatures, so set the dial to
•
Put the switch in ON position ("I") and set the temperature dial of the iron to the desired
position. When the iron has reached the desired temperature, its pilot light will go out. You
can now use the steam function.
•
Turn the steam control knob to regulate the amount of steam. Note: the maximal steam
rate ("MAX") can only be used when the ironing temperature is higher than position
or else water will drip from the sole.
•
Press the steam button to release steam from the soleplate of the iron. Release the button
and the steam will stop. If you want a continuous jet of steam, press the steam button
down and slide its transparent top part backwards so that the steam button locks. To stop
the continuous jet of steam, push the transparent part of the button forward again and
release the steam button.
•
When ironing, the pilot light of the iron will go on and off from time to time. This means that
the temperature of the iron is regulated by its thermostat. You can continue ironing. The
pump pilot light will also go on and off, indicating that the steam pressure is being
regulated.
•
When you use a lot of steam in a very short time, the steam output is lightly reduced until
your appliance produces enough steam to reduce the difference. This phenomenon also
happens when there isn't enough water in the water tank.
•
When the water tank is running empty, you will hear more noise when pressing the steam
button. If you want to go on using the steam function, you will have to refill the water tank.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
or
15
Assembly page 15/64
.
TKG SIS 1001 - 130827
,