Tabla de contenido
Publicidad
Darning
Machine setting
q Pattern
w LED display
e Foot
R: Automatic buttonhole foot
z Pull the button holder fully to the back.
x Draw the needle thread to the left through the hole
on the foot.
c Lower the needle into the fabric at starting point.
Lower the foot and depress the foot control.
The machine will darn and stop automatically. The
LED display will show a blinking dot when the
darning is finished.
NOTE:
The maximum length and width of the darning are
2 cm and 0.7cm respectively.
Sew another layer of darning over the previous one, at
the right angle.
q Button holder
w Starting point
e Maximum length (2 cm)
r Maximum width (0.7 cm)
t Blinking dot
a a a a a To sew a shorter darning
Sew the first row to the required length and press
the reverse stitch button. Continue to sew the
remaining stitches until the machine stops
automatically.
y Reverse stitch button
u Required length
s s s s s Adjusting the evenness of the darning
Press the mode selection key to enter the stitch
length adjusting mode.
The LED display shows d5, which indicates the
neutral setting.
(A) If the left corner is lower than the right side,
press the Up (+) key to correct it.
(B) If the right corner is lower than the right side,
press the Down (–) key to correct it.
NOTE:
Allowable adjustment range is d1-d9.
q
z x c
q
w
a a a a a
y
s s s s s
(A)
58
w
e
e
v
t
u
r
(B)
Publicidad
Tabla de contenido
