turbionaire Senso 12 Manual De Instrucciones página 12

MODE
Auto mode - Continuously drying mode – Sleeping mode cycle, press once to
switch the mode from one to another, the corresponding indicator lights up.
•
Auto mode: when environmental humidity ≥ set humidity 3%, the fan starts working
and compressor starts working after 3 seconds. When environmental humidity ≤ set
humidity -3%, the compressor stops working and fan stops working after 30 seconds'
delay. Both fan speed and humidity can be adjusted under auto mode.
• Continuously drying mode: The machine continues to run, but the humidity cannot be
adjusted.
•
Sleeping mode: Touch the sleep button, the button lights up and start the sleep
function. If the control panel is not operated within 10 seconds, all indicators turns dark
gradually and the fun speed is automatically switched from high to low. Touch any
button to wake up the SLEEP Mode indicator. Touch MODE button again to exit the SLEEP
mode.
When environmental humidity ≤ 57%，compressor stops working and the fan shut down
after 30 seconds' delay.
When environmental humidity ≥ 63%，the fan starts working and compressor starts
working after 3 seconds.
Fan speed and humidity cannot be adjusted under SLEEP mode.
TIMER
Press the timer button to set the 0-12 hour timing function. The interval is 1 hour.
Each time you press this button, the value increased 1 hours and then the corresponding
timing value is displayed on the screen. The setting value is "00" to cancel the timer
function. The indicator turns out. After the timer is set and completed, the timer LED is on
during the timing period. After the timing is over, the timer LED turns off automatically.
In the running state, set the time to turn off the machine;
In the standby state, set the time to turn on the machine.
HUMIDITY SET
Touch the humidity button (HUM SET) to check the current environment humidity,
touch this button again and you can set the humidity. The range of target humidity is 30%-
35% - 40% - 45% - 50% - 55%- 60% - 65% -70% - 75%- 80%. After setting 3 seconds,
the system confirms the input value and then the machine exits the setting state, and
returns the current humidity. In the drying mode, the target humidity cannot be changed.
Long Press humidity button for 3 seconds to display the current ambient temperature.
FAN SPEED (SPEED)
High wind - low wind cycle, press button once to switch and then the corresponding
LED indicator lights up. In continuously drying mode, sleep mode and defrosting period, the
wind speed cannot be changed.
12