dirna Bergstrom Bycool Split Instrucciones De Montaje página 13

SPLIT
EVAPORATOR
1- Position the evaporator unit in the most
appropriate part of the cabin (roof, floor,
dashboard, etc.).
2- Mark the evaporator support points.
3- Bore Ø7 holes for throughbore or Ø9 to
position M6 rivet nuts.
4- Secure the evaporator with (4) 6/100x15
screws and grower and flat washers if M6
rivet nuts have been positioned, and with (4)
6/100x20 screws in the case of throughbores
(when secured to the roof, introduce screws
with flat and rubber washers on the outside
of the cabin and secure on the inside using
flat washers and M6 nuts on the inside; this
will prevent water from entering the cabin).
5- Place nut caps on the inside of the cabin.
1
evaporator on the ceiling
evaporator on the floor
1
Air conditioning for vehicles
2
4
5
13
EN
4
4