YATO YT-82903 Manual De Instrucciones página 13

PRODUCT SPECIFICATION
The cordless polisher is a universal, portable tool which does not require an external power source, designed for DIY enthusiasts
to polish and grind surfaces made of diff erent materials with abrasive paper. Its specifi c advantages will be appreciated by DIY
enthusiasts performing various assembly and fi nishing works. As the proper use of the power tool is a condition for the correct,
reliable and safe operation of it, please
Read and keep the entire manual before the fi rst use of the tool.
The manufacturer shall not be held liable for any damage resulting from failure to observe the safety regulations and recommen-
dations specifi ed in this manual.
ACCESSORIES
The product is supplied complete and does not require assembly. The product comes with: battery, charging station (charger),
additional handle, polishing disc and sponge polishing pad.
TECHNICAL PARAMETERS
Parameter
Catalogue No.
Operating Voltage
Revolutions (idle speed)
Noise level
- sound pressure
- power L
wA
Ingress protection rating
Protection class
Vibration level
Weight
Tool holder
Maximum grinding disc diameter
Battery type
Battery capacity
Charger
Input voltage
Power frequency
Output voltage
Output current
Rated power
Charging time
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fi re or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain infl ammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fi re in case of contact with infl ammable gases or vapours.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fi t the mains socket. Do not modify the plug. Do not use any adapters what-
soever in order to adapt the plug to the socket. Unmodifi ed plug which fi ts the socket reduces the risk of an electric shock.
Avoid contact with grounded surfaces, such as pipes, heaters and refrigerators. Grounding of the body increases the risk
of an electric shock.
O R I G I N A L
GB
Units
[V]
[min ]
-1
[dB]
[dB]
[m/s ]
2
[kg]
['']
[mm]
[Ah]
[V]
[Hz]
[V]
[A]
[W]
[h]
I N S T R U C T I O N S
Value
YT-82903
12 DC
1: 0 – 2800 / 2: 0 - 8300
78.6 ± 3.0
89.6 ± 3.0
IP20
III
4.213 ± 1.5
0.7
5/16 (8 mm)
80
Li-ion
1.5
100 - 240
50 / 60
12
2
35
1
13