Self-Centering Chuck Sliding Table Adjustment - Bosch TCE 4530 Instrucciones De Réparation

en 24 | TCE 4530 | Adjustments
3.9 Self-centering chuck sliding table
adjustment
Check procedure of the appropriate functioning of the
self-centering chuck, of the sliders and replacement of
the reducer gear.
Correct functioning check:
1. Mount a wheel on the self-centering chuck;
2. Check that there are no excessive plays on the self-
centering chuck table;
If there are excessive plays of the device proceed as
follows:
3. Disconnect power supply;
4. Open the RT side door;
5. Remove the self-centering chuck:
$
Extract the central shaft;
$
Unscrew the central locking nut with a 14mm long
wrench;
$
Extract the self-centering chuck;
$
Extract the plastic transmission bushings;
$
Remove the central connection that maintains the
tool aligned with the axis;
$
Remove the two metal sheet closing covers.
6. Disconnect the clip of the hydraulic cylinder N°2
releasing thus the self-centering chuck;
7.
Unscrew the support screws of the right sliding slid-
ers;
8. Proceed with adjusters replacement;
$
Warning: for an easier assembling it is adviced to
use a generous quantity of grease, to maintain all
pieces in position.
|
1 695 104 942 2008-10-17 Robert Bosch GmbH