SCAN Andersen 4 Instrucciones Para Instalación página 37

4.3 Chimneys and fl ue pipes
• The fireplace can be connected to a chimney and flue
pipe approved for solid fuel fi red appliances with fl ue gas
temperatures specifi ed in «2.0 Technical data".
• The chimney's cross-section must be at least as big as the
fl ue pipe's cross-section. See «2.0 Technical data» when
calculating the correct chimney cross-section.
• Several solid fuel fi red appliances can be connected to the
same chimney if the chimney's cross-section is suffi cient.
• Connection to the chimney must be carried out in
accordance with the installation instructions from the
supplier of the chimney.
• Before making a hole in the chimney the fi replace should
be test-mounted in order to correctly mark the position
of the fi replace and the hole in the chimney. See fi g. 1 for
minimum dimensions.
• Ensure that the fl ue pipe is inclined all the way up to the
chimney.
• Use a fl ue pipe bend with a sweeping hatch that allows it
to be swept.
Be aware of the fact that it is particularly important that
connections have a certain flexibility in order to prevent
movement in the installation leading to cracks.
Chimney draught; See «2.0 Technical data». If the draught is
too strong you can install and operate a fl ue damper to control
the draught.
4.4 Assembly prior to installation
• The product comes ready assembled in two packages:
• Remove the product from the packaging and check for visible
damage and that the control handles work. Lift the ash lip
and service box out of the burn chamber.
• IMPORTANT!: A sheet of foam plastic is placed between
the baffl e and the exhaust defl ector for protection during
transport. Be sure to remove this before using the fi replace
for the fi rst time.
4.5 Fitting the convection panels
Fig. 3
3
1. Fit the convection panels (Fig. 3 - 1) using the screws and
washers provided (Fig. 3. - 2).
4.6 Fitting the soapstone panels
(optional extra)
Fig. 4
5
3
2
1. Fit the legs (Fig. 4 - 1) using the screws (Fig. 4 - 2) and adjuster
screws (Fig. 4 - 3).
2. Fit the legs (Fig. 4 - 1) using the screws (Fig. 4 - 2) and adjuster
screws (Fig. 4 - 3).
3. Secure the soapstone panels (Fig. 4 - 4) using nuts and bolts
(Fig. 4 - 5).
ENGLISH
1
2
5
1
4
37