Troubleshooting
Problem
The appliance
does not operate.
When epilating
When epilating
or shaving
The usage time is
shortened.
When epilating
Cannot remove
hair.
The hair becomes
stubble.
The appliance
When epilating
stops during
operation.
The appliance is
not removing the
hair as well as
before.
14
ES-EU20_AM.indb
14
Possible cause
It is not charged.
The switch is turned ON with the adaptor
connected to the household outlet.
Discs are deformed, cracked, or damaged.
Hair dust has accumulated.
Shower gel has adhered to the discs and blade.
The appliance is not used at recommended
temperature.
The appliance is pressed against skin too hard.
Not fully charged.
The appliance is used on long hair.
The way the unit is applied or moved is not
correct.
The appliance is pressed against skin too hard.
Not fully charged.
Hair dust has accumulated.
Discs are deformed, cracked, or damaged.
Action
Fully charge the appliance.
Charging is only possible when
connected to the household outlet.
Disconnect from the outlet before use.
Request repair at an authorized
service center.
Clean the hair dust.
Wash it off by soaking in warm water.
Use at the recommended use
temperature of 0 - 35 °C (32 - 95 °F).
Contact skin with gentle force.
Fully charge the appliance.
Use on hair approximately 2 to 3 mm
long (approximately 1/8").
Refer to page 12.
Contact skin with gentle force.
Fully charge the appliance.
Clean the hair dust.
Request repair at an authorized
service center.
2014/12/04
17:09:20