Softener; Starting Washing; Pausing Washing; Loading Laundry Into The Drum - Schneider SLA 6100 Manual De Usario

less fabric softener. Furthermore, the liquid
detergent does not leave any type of solid
residues inside the washing machine and in
the drainage system. Thus eliminating the long
standing problem of incrustation and ruining of
the tubes. It washes well also in cold water and
is ideal for coloured clothes because it does
not interact with the fabric colours, rather the
colour is preserved and protected with time.
It should be used within temperature range of
0°C and 90°C. The temperature depends on
the fabric (refer to the labelling and by grade
of dirt). The whiteness efficiency is obtained
instead only at temperatures above 50°C. In the
liquid detergent there is no sodium perborate,
but the optical bleaching agent that works well
only beyond a certain temperature.
recommended temperature cold - 90°c

softEnEr

The softener is very high concentrate, which
is deposited on the laundry fibres and makes
them soft. It should be used sparingly or diluted
with water, 50% and more. It facilitates ironing
of clothes washed.
The fragrances are due to different essences
added to the additive and it does not in any way
impair the ability of cleaning product.
DEtErgEnt DosEs
The doses vary depending on the type of water:
with hard or averagely hard water it takes a
greater amount of product compared to that soft
water, as it is typically printed on the label of
the various products. In general, using quality
products, very little quantity of detergent would
be enough. It is always recommended to use
20% less than usual!
24
starting WasHing programmE
1. To start the washing program turn the
programme selection knob onto the desired
programme.
2. Evaluate the opportunity to customise
the washing programme by adjusting the
temperature with the button No. 2, the
spin (button 3) or selecting one or more of
the special functions provided (see wash
options on page 17).

starting WasHing

After the steps above washing can be started
by pressing the Start/Pause button.

pausing WasHing

It is possible to stop the wash cycle by pressing
the Start/Pause button. The machine will go to
standby mode. If there is a need to change the
programme, the knob No. 1 must be turned to
OFF position before selecting new programme.
At the end of the wash cycle, the red LED turns
off and the door can be opened only if the drum
is not empty of water.

loaDing launDrY into tHE Drum

For proper washing, it is necessary to load the
drum possibly with loose laundry one at a time.
This is to prevent nodding. The washing
efficiency is strongly influenced by the way and
the amount laundry. In general, an excessive
or less than half the rated capacity (see
technical data table page 17), puts strain on
the 'reliability of the washing machine and
generates more noise in the machine.
in the case of excessive loads or below
the nominal capacity and uneven, it is
appropriate to minimize the spin speed to
avoid strong vibrations during spinning.