Messages That May Show Up - Resonance r26m Manual Rápido Del Usuario

Messages that may show up

Message on When it appears
display
RUNNING It appears during performance of
TEST middle ear analyzer tests
PRESSURIZE It appears during middle ear
analyzer tests when a pressure
generation request is entered
PUMP RESET It appears during middle ear
analyzer tests when the pump is
reset back to default status
RUNNING It is highlighted in a yellow box
TYMP during middle ear analyzer reflex
testing when an automatic peak
compliance detection request
has been entered
PEAK It is highlighted in a yellow box
SEARCH during middle ear analyzer reflex
testing when an automatic peak
compliance detection request
has been entered
PROBE OPEN It appears during middle ear
analyzer tests when the cavity
values recorded by the device
are higher than the maximum
value that is acceptable for test
performance
PROBE CLOSED It appears during middle ear
analyzer tests when the cavity
values recorded by the device
are lower than the minimum
value that is acceptable for test
performance
WAIT It appears during middle ear
analyzer reflex testing, in the
time gap between each stimulus
emission
Message Meaning
type
System It means that the test is
message being performed
System It means that pressure
message is being generated in
the cavities the probe
has been inserted into
System It means that the
message pump has been reset
back to default status
System It means that the
message tympanometric graph
is being plotted
System It means that the
message device is automati-
cally running a peak
compliance detection
process
Error It means that the cavity
message value read off by the
device is higher than
the maximum value
that is acceptable for
test performance
Error It means that the cavity
message value read off by the
device is lower than
the minimum value
that is acceptable for
test performance
System It means that it is
message necessary to wait for
the next stimulus
Troubleshooting
No action is required
No action is required
No action is required
No action is required
No action is required
Check to ensure that the
probe is inserted with an
acceptable cavity value
and that the cone-sha-
ped end section of the
actual probe has been
firmly closed
Check to ensure that the
probe is inserted with an
acceptable cavity value
and that probe exit is not
obstructed in any way
No action is required
41