Cristher OnLED PAR56 Manual Del Usuario página 5

The Modulator is connected to the 230 V~ac mains by means of two terminals indicated MAINS, and to the primary
input of the transformer (230 V~ac) by means of the terminals indicated TRF.
The Transformer must be dimensioned to supply the corresponding VA to each LED lamp which is connected (see
table on back page). For example, if we want to control 4, 70VA PAR56 v2 lamps we must connect them in parallel to
a minimum 300VA transformer.
Each modulator can support up to a maximum of 900VA.
Once the unit is connected, proceed as follows to start-up the projector for the first time:
Switch on the unit by activating the 230 V~ac at the input of the Modulator, which will automatically syntonize with the
transformer. The green LED of the Modulator will flash every 2 seconds and the lamp will remain off.
Types of lighting
The Remote Control – Modulator – Transformer – LED Projector unit enables you to create different lighting settings
inside the pool with two operation options:
Set colour: Selection of a set colour among twelve possibilities.
COLOUR Nº
1
2
3
4
5
6
Automatic sequence of colours: Selection of eight colour sequence programmes. Each programme is defined by
the lighting time of each colour and the transition time from one colour to another according to the following table:
SEQUENCE
1 Red Green
2 Cyan Magenta
3 Green Esmerald green Cyan
4 Red Orange
5 Red Pink
6 Red Orange
7 Pale violet Magenta
8 Red Green
7. SAFETY WARNINGS:
• Avoid making contact with the electric voltage.
• Comply with the current standards regarding accident prevention.
• In this regard, the IEC 364-7-702 standards must be observed: WIRING IN BUILDINGS SPECIAL WIRING
SWIMMING POOLS
• All maintenance operations should be performed with the lamp disconnected from the Mains.
• Do not handle with wet feet.
• The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any elec-
tric components which have been inserted or handled at locations other than its own premises.
• The PAR56 lamp of LEDs withstands to the treatments of swimming pool described next as long as the
values of concentration do not surpass the following values:
TYPE OF TREATMENT
Chlorine
Bromine
Salt electrolysis (Na Cl)
Attention : Please note that the Ph of pool water always must be between 7.2 and 7.6.
COLOUR
Red
Green
Blue
Yellow
Cyan
Magenta
ORDER OF COLOURS
Blue
Yellow
Sky-blue
Green Orange
Blue Pink
Green Cyan Blue
Cyan Yellow White
Blue Yellow Cyan Magenta Pale violet Sky-blue
5
COLOUR Nº
7
8
9
10
11
12
Pink
Yellow Cyan Magenta
CONCENTRATION IN WATER
2 g/l
5 g/l
6 g/l
COLOUR
Pale violet
Sky-blue
Orange
Pink
Emerald green
White
Orange Pink Esmerald green White