Catalonia Aqua Spa Manual De Instalación página 16

ELECTRICAL CONNECTION ENG
Some configurations may require installing 1 32A line, 2 16A lines or even one three-phase line (3
x 16A) to cover the power required by the Spa.
The different configuration options of the electrical control panel are explained further on in this
Installation Manual.
Remember that the installation and any changes in the electric configuration must be carried out
by qualified personnel, following the current regulations in each country.
The manufacturer shall not be responsible for any damage caused by an improper installation or
an installation performed by non-qualified personnel.
ATTENTION
Pay attention to the position of the maximum consumption switch.
The Spa will not operate properly if a cable not corresponding to the distance and power of the
Spa is used, and the electrical circuits may overheat which may cause an electrical accident.
Always use cable with the suitable section of maximum consumption. In the event of doubt
between two values, always use the cable with the greater section.
To connect the supply to the electrical panel of the Spa, locate the packing gland positioned at one
end of the electrical panel.
Make sure that there is no electric current in the connection cable (differential switch in the OFF
position).
Take the cable to the Spa electrical panel.
Open the cover of the electrical cabinet, insert the feed cable through the free side.
Attention: the indicated blue cable is neutral, and the brown cable indicates the line or phase.
Fasten the terminals as indicated in the following diagrams and the type of electrical supply
17