Common Operation Malfunctions
Malfunction
Possible Reasons
Power plug is not properly
1:Heater
connected
cannot start
Safety setting cut off the circuit or
the fuse of the electric circuit is
burned
Socket does not work
Safety setting cut off the circuit or
2:Power is on
the fuse of the electric circuit is
but heater
burned
cannot work
Working of Safety Tilt Auto Shut-
off Device
Safety setting cut off the circuit or
3:Heater stops
the fuse of the electric circuit is
working by
burned
itself.
NOTICE: IF ANY OF THE ABOVE COUNTERMEASURES CANNOT RESOLVE
THE MALFUNCTION, PLEASE CONTACT THE APPOINTED SERVICE CENTER
OR SUPPLIER RIGHT AWAY.
IMPROVEMENT AND DEVELOPMENT, WE THEREFORE HOPE THAT YOU WILL
UNDERSTAND WE MUST RETAIN THE RIGHT TO AMEND DETAILS AND/OR
SPECIFICATIONS WITHOUT PRIOR NOTICE.
WEEE
This appliance must not be disposed together with the domestic waste. This
appliance has to be disposed at an authorized place for recycling of electrical
and electronic appliances. By collecting and recycling waste, you help save
natural resources, and make sure the product is disposed in an
environmental friendly and healthy way.
Should there be any discrepancy between the Spanish version and the English version of this
Instruction Manual, the English version shall prevail
MALFUNCTION AND EXAMINATION
AS OUR POLICY IS ONE OF CONTINUOUS
Countermeasure
Disconnect the power plug from the
electric power supply and reconnect
again.
Redesign the safety setting or enlarge the
rating capacity of the fuse of the electric
circuit.
Repair the socket by qualified and
experienced electrician.
Replace the fuse of the electric circuit by
qualified and experienced electrician.
Place the heater in a vertical position on
flat ground.
Replace the fuse of the electric circuit by
qualified and experienced electrician.