Publicidad
Idiomas disponibles
Idiomas disponibles
ENG: Installation Instructions Bilstein 2.65" Prerunner shocks
Attention! Not reading these instructions prior installing this kit may cause irreversible
damage and/or harm to the shock and/or other vehicle components. This kit should be
only installed by professionals and 4x4proyect.com cannot be held responsible for any
damage and/or harm caused by improper installation.
Thank you for your trust in 4x4 Proyect Design. The product you have acquired has been thoroughly tested
under multiple conditions to guarantee its quality before releasing it for sale.
The 4PD-JPJK2K kit includes all necessary hardware and parts to install 4 Bilstein 2.65" Prerunner shocks on a
Jeep Wrangler JK. The resulting suspension travel is 10"/250mm at the front and rear axle. The Bilstein 2.65"
Prerunner shocks have been designed and manufactured in Spain by our professional staff to guarantee the
highest standards.
Important:
-
Application: 2007-2019 Jeep Wrangler JK & JK Unlimited
-
Lift range: 0-3.5"/0-89mm
-
Different valvings exist depending on variant and desired load. These shocks have been valved
for a specific weight and spring rate. If you have any doubts about the correct weights and rates
get in touch with your authorized distributor 4x4 Proyect Design. If you're not sure to have
obtained the correct valving contact us before beginning the installation.
-
The Bilstein 2.65" Prerunner shocks are among the most robust ones on the market. Its
components come straight out of the racing world and will give you many years of dependable
service if properly maintained.
-
Show some love for your shocks! Carry out regular visual inspections of your shocks to identify
signs of wear, especially after heavy off road use. Rinse them off with water after off road use
and don't let them dry with dirt or mud on them.
-
The Bilstein 2.65" Prerunner shocks are completely self-adjusting and don't require external
adjustments. If you require a different setup get in touch with your distributor to help you find
a suitable valving.
-
Never change the nitrogen pressure for any reason. Incorrect nitrogen pressure will result in
irreversible shock damage and loss of official warranty.
-
For optimum performance in off road use it is mandatory to check the available compression
length once installed. Ideally there will be 6"/150mm of available compression with the vehicle
static and normally loaded. 5"/125mm is the minimum available compression. To check the
available compression measure the visible portion of the rod including the three stage orange
bumpstop with the vehicle at rest.
-
It is mandatory to correctly install extension limiters that stop the shock 10mm before the end
of its travel to avoid internal damages and/or premature wear and failure of valves and pistons.
The warranty will not cover and damages caused by wrong installation or omission of limiting
straps.
-
If you frequently drive in environments with high salinity we recommend an upgrade to
stainless steel bearings.
Kit components:
1x 4PD-JP005AL Bilstein 2.65" Prerunner front left shock Jeep Wrangler JK 0-3"
1x 4PD-JP005AR Bilstein 2.65" Prerunner front left shock Jeep Wrangler JK 0-3"
Publicidad
