Technical Data - MedicPro NUK Instrucciones De Operación

Problem
Indicator is lit up red No bottle in
Indicator flashing
red
Device not
responding
Food too cold
Food too hot
Surface of device is
getting very warm /
hot
The fan in the device
continues to run
even though the
heating of the bottle
has been completed
Dimensions:
Weight:
Power supply:
Power consumption:
Degree of protection:
Protection class:
Environmental conditions:
- Operation:
- Storage / transport:
Filter used:
Possible cause
device, device is
still warm
Bottle/food too
hot
Bottle size not
suitable for quan-
tity of liquid
Critical fault
Device not con-
nected to power
supply
Overheating cut-
out tripped (fuse)
Quantity of liquid
to be heated is
very large
Bottle size not
suitable for quan-
tity of liquid
Filter clogged
Air inlet is blocked Air inlet should not be blocked (see "4.2 Setting
Unit is still too hot
and must be
cooled down

9. Technical data

160 x 135 x 175 mm
1.5 kg
~
220-240 V / 50-60 Hz
3.4 A / 900 W
I
IP22
temperature: +15 °C to +37 °C
humidity: 20% to 65% RH
temperature: -10 °C to +50 °C
humidity: 20% to 90%
class G3
Device can be used: Insert bottle and press oper-
ating button 5
Check food temperature.
Select suitable bottle size: With small quantities of
liquid, use small bottles
Select suitable bottle size: With small quantities of
liquid, use small bottles
Do not continue using device. Contact Service
(see "Contact addresses" on page 55)
Check and connect if necessary
See "5.4 Overheating cut-out" on page 23
Heat bottle again (see "5.1 Heating food" on
page 22)
Select suitable bottle size: With small quantities of
liquid, use small bottles
Replace filter (see "7.1.1 Replacing the filter" on
page 24)
up" on page 21)
None, the fan switches off automatically after
sufficient cooling
25
Measures