Optimizing The Speaker Settings Automatically (Ypao) - Yamaha RX-A3030 Guía De Configuración Sencilla

5

Optimizing the speaker settings automatically (YPAO)

The Yamaha Parametric room Acoustic Optimizer (YPAO) function detects speaker connections, measures the
distances from them to your listening position(s), and then automatically optimizes the speaker settings, such as
volume balance and acoustic parameters, to suit your room.
• During the measuring process, test tones are output at high volume. Ensure that the
test tones do not frighten small children. Also, refrain from using this function at night
when it may be a nuisance to others.
• During the measuring process, you cannot adjust the volume.
• During the measuring process, keep the room as quiet as possible.
• Do not connect headphones.
• Do not stand between the speakers and the YPAO microphone during the
measurement process (about 3 minutes).
• Move to the corner of the room or leave the room.
Preparing for YPAO
Turn on the subwoofer and set
the volume to half. If the
cross-over frequency is
adjustable, set it to maximum.
CROSSOVER/
VOLUME HIGH CUT
MIN MAX MIN MAX
6
En
The unit (front)
YPAO MIC
YPAO
microphone
Ear height
Place the YPAO microphone at your
listening position (same height as your
ears). We recommend the use of a
tripod as a microphone stand. You can
use the tripod screws to fix the
microphone in place. (The microphone
direction is not considered.)
SOURCE RECEIVER
SOURCE/RECEIVER
AV AV
1 1 2 2 3 3 4 4
5 5 6 6 7 7 V-AUX V-AUX
AUDIO AUDIO
1 1 2 2 3 3 4 4
PHONO PHONO MULTI MULTI L L USB USB NET NET
[ A ] [ A ] [ B ] [ B ] [ C ] [ C ]
TUNER TUNER
SCENE SCENE
1 1 2 2 3 3 4 4
PROGRAM PROGRAM MUTE MUTE VOLUME VOLUME
TOP MENU TOP MENU POP-UP/MENU POP-UP/MENU
ON SCREEN ON SCREEN OPTION OPTION
Cursor keys
ENTER
ENTER
RETURN
RETURN DISPLAY DISPLAY
MODE MODE
LIVE LIVE
CLASSICAL CLASSICAL CLASSICAL ENTERTAI T T N ENTERTAIN
CLUB CLUB
PRESET PRESET
MOVIE MOVIE STEREO STEREO STRAIGHT STRAIGHT
TV TV
PURE PURE
INPUT INPUT
DIRECT DIRECT
TV VOL TV VOL TV CH TV CH
MUTE MUTE
1
Connect the YPAO microphone to the
YPAO MIC jack on the front panel.
The following screen appears on the TV.
• To cancel the operation, disconnect the YPAO microphone
before starting the measurement.
2
To start the measurement, use the cursor
keys to select "Measure" and press
ENTER.
The measurement will start in 10 seconds.
The following screen appears on the TV when
the measurement finishes.
• If the cursor keys do not work, press SOURCE/RECEIVER (to
light up the key in orange) and then use the cursor keys.
• If any error message (such as E-1) or warning message (such
as W-2) appears, see "Error messages" or "Warning
messages" in "Owner's Manual".
• If the warning message "W-1:Out of Phase" appears, see
"If "W-1:Out of Phase" appears" (next page).