If you experience a problem, follow this guide. You may also want to visit our Web site at: www.desatech.com. If the
problem persists, call* for assistance at 1-800-858-8501, 7:30 AM to 4:30 PM CST (M-F). You may also write* to:
DESA Specialty Products™
P.O. Box 90004, Bowling Green, KY 42102-9004
ATTN: Technical Service Specialty Products
* If contacting Technical Service, please have the following information available: Model Number, Date of
Purchase, and Place of Purchase.
No Service Parts Available for this Product
SYMPTOM
POSSIBLE CAUSE
Light will not come
1. Light switch is turned off.
on.
2. Halogen lamp is loose or burned
3. Fuse is blown or circuit breaker
4. Daylight turn-off is in effect.
5. Incorrect circuit wiring, if this is
6. Not aimed correctly. (Re-aim the
Light comes on in
1. Light Control may be installed
daylight.
2. Light Control is in TEST. (Select
Light comes on for
1. Light Control's sensor may be
no apparent reason.
2. Sensitivity is set too high. (Re-
This is a "Limited Warranty" which gives you specific legal rights. You may also have other rights which vary from state
to state or province to province.
For a period of one year from the date of purchase, any malfunction caused by factory defective parts or workmanship
will be corrected at no charge to you. Light bulbs are not covered. To obtain a refund or a replacement, return the product
to the place of purchase.
Not Covered - Repair service, adjustment and calibration due to misuse, abuse or negligence, light bulbs and other
expendable items are not covered by this warranty. Unauthorized service or modification of the product or of any furnished
component will void this warranty in its entirety. This warranty does not include reimbursement for inconvenience,
installation, setup time, loss of use, or unauthorized service.
This warranty covers only DESA Specialty Products™ assembled products and is not extended to other equipment and
components that a customer uses in conjunction with our products.
THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY
WARRANTY, REPRESENTATION OR CONDITION OF MERCHANT ABILITY OR THAT THE PRODUCTS ARE FIT
FOR ANY PARTICULAR PURPOSE OR USE, AND SPECIFICALLY IN LIEU OF ALL SPECIAL, INDIRECT, INCIDEN-
TAL, OR CONSEQUENTIAL DAMAGES.
REPAIR OR REPLACEMENT SHALL BE THE SOLE REMEDY OF THE CUSTOMER AND THERE SHALL BE NO
LIABILITY ON THE PART OF DESA SPECIALTY PRODUCTS™ FOR ANY SPECIAL, INDIRECT, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO ANY LOSS OF BUSINESS OR PROFITS,
WHETHER OR NOT FORESEEABLE. Some states or provinces do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation or exclusion may not apply to you. Retain receipt for warranty claims.
TECHNICAL SERVICE
(Do Not Send Products)
TROUBLESHOOTING GUIDE
out.
is turned off.
(Recheck after dark.)
a new installation.
sensor to cover desired area.)
in a relatively dark location.
1, 5 or 10 minutes for AUTO time.)
detecting small animals, sway-
ing trees, or automobile traffic.
(Re-aim sensor.)
duce sensitivity.)
ONE YEAR LIMITED WARRANTY
SYMPTOM
POSSIBLE CAUSE
Light stays on
1. The halogen lamp is positioned
continuously.
2. Light Control's sensor is pointed
3. LIght Control is in Manual Mode.
Light flashes on
1. Heat or light from the halogen lamp
and off.
2. Heat being reflected from other
3. Light Control is in the TEST mode
4
too close to the Light Control's
sensor or pointed at nearby objects
that cause heat to trigger the
sensor. (Reposition the lamp away
from the sensor or nearby objects.)
toward a heat source like an air
vent, dryer vent, or brightly-painted
heat-reflective surface. (Reposition
sensor.)
(Switch to Auto.)
may be turning the Light Control
on and off. (Reposition the lamp
away from the sensor.)
objects may be affecting the Light
Control. (Re-aim sensor) .
and warming up. (Flashing is
normal under these conditions.)
595-5496-06