Ford Distributing G19503040 Instrucciones Para El Uso página 16

QUICK COUPLER
The Quick Coupler must be used only with hydraulic lifting system.
1) Install hitch Quick Coupler (A, Fig. 23) on the tractor (see
tractor operator manual).
2) Stop vehicle on a level surface, not on a slope, then moving
back to the tractor until the Quick Coupler (A) is range
with the (B and C, Fig. 23) hitch points of the sickle bar.
3) Raise the Quick Coupler (A, Fig. 23) and make sure that
sickle bar hitch is in the right position (E, Fig. 24).
CAUTION: Before you work around hitch:
• STOP engine.
• LOCK park brake.
• FIRMLY block mower on horizontal surface.
Removing sickle bar with Quick Coupler
1. Raise sickle bar.
2. Put parking stand (F and G, Fig. 25) in the DOWN position:
install spring locking pin in order to secure parking stand
(H , Fig. 25).
3. Lower sickle bar to the ground.
4. Raise the two Quick Coupler levers (D, Fig. 23) to unloch
sickle bar.
5. Lower Quick Coupler till further free the sickle bar.
16
D
A
C
E
H
B D
C
Fig. 23
Fig. 24
F
G
Fig. 25
cod. G19503040