Dry Ironing; Steam Ironing - Sigete SG-5078 Manual Del Usuario

5 ENGLISH
•
Always place the iron on a stable, flat,
heat-resistant surface. Ensure that the
surface can take the weight of the unit
during use and also when the iron is
resting on its stand.
•
Do not allow the power cord to hang
over sharp table edges or come into
contact with hot surfaces.
•
Do not use the iron outdoors.
•
Always switch the power OFF before
removing the plug from the mains
electrical supply.
USING THE STEAM IRON
BEFORE FIRST USE
1. Before using the iron for the first time,
check that the voltage and power
supply comply with the specifications
indicated on the rating plate of the
appliance.
2. It is normal for a small amount of smoke
to be produced the first time the iron is
used. This will disappear quickly.
3. Remove any sticker or protective foil from
the Soleplate. Clean the Soleplate with a
soft cloth.
4. Keep the Soleplate smooth. Avoid hard
contact with metal objects (such as
clothes rack, button and slide fastener).
5. Pure woolen fabrics (100% wool) may be
pressed with the iron set to a steam
position. Preferably set the steam
regulator to a strong position, and use a
dry pressing cloth.
FILLING WITH WATER
1. Make sure the iron is unplugged and the
Temperature Control Dial [7] is in the MIN
position.
2. Hold the iron upright so that the Water
Filling Inlet [1] is in a horizontal position.
3. Fill the Water Tank [10] through the Water
Filling Inlet until the water reaches the
MAX filling level. Do not exceed the MAX
filling level.

DRY IRONING

1. Set the Dry/Steam Selector [5] to position
"O" (= no steam).
2. As per the washing label of various
clothes, set the correct ironing
temperature to begin ironing.

STEAM IRONING

1. Fill the Water Tank [10] with water as per
the water-filling methods.
2. Place the iron in a vertical position and
insert the plug into the mains electrical
supply.
3. Set the Temperature Control Dial [7] to
the MAX position and wait until the iron
heats up and the Temperature Indicator
Light goes out.
4. Set the Dry/Steam Selector to the desired
position. Increase steam output by
pushing the switch back and decrease
steam by forwarding it.
BURST OF STEAM
1. Press the Burst of Steam Button [4] to
generate a powerful burst of steam in
order to penetrate the fabric and smooth
the toughest creases.
2. For an optimal result, wait for 5 seconds
before pressing the button again (max
6-7 times).
3. In order to prevent leaking water from
the Soleplate, do not press the steam
button continuously for more than 5
seconds.
4. Also allow at least 1 minute interval
before applying the burst of steam
function again.
i
Note
The burst of steam function can only be used
on the high temperature setting.
i
Note
This function can also be applied when the
iron is in a vertical position. Ideal for removing
creases on curtains, hanging suits etc.
SPRAYING
Press the Spray Button [3] to spray water on
clothes as often as required.