Sigete SG-5078 Manual Del Usuario página 6

6 ENGLISH
i
Note
When using the water spray function, ensure
that there is enough water in the Water Tank.
You may have to pump the Spray Button
several times the first time in order to start the
spraying function.
SELF-CLEANING
The self-cleaning feature cleans the inside of
the Soleplate; thereby removing impurities.
We recommend using the self-cleaning
function every 14 days. If the water in your
area is very hard (when flakes come out of
the Soleplate during ironing), the self-cleaning
function should be used more frequently.
1. Make sure the iron is unplugged.
2. Set the Dry/Steam Selector [5] to steam
level "O".
3. Fill the Water Tank [10] to the MAX filling
level (do not put vinegar or any other
descaling product in the Water Tank).
4. Set the Temperature Control Dial [7] to the
MAX position.
5. Plug the iron into the mains electrical
supply.
6. Leave the iron switched on, rested on its
heel until the Temperature Indicator Light
goes out.
7. Unplug the iron from the mains electrical
supply.
8. Whilst the iron is still very hot, hold the iron
horizontally over a sink.
9. Press the Self-Cleaning Button [9]. The self-
cleaning starts working.
10. Gently move the iron back and forth.
Steam and boiling water will come out of
the Soleplate. Impurities and flakes (if any)
will be flushed out.
11. Repeat the self-cleaning process if the
iron still contains a lot of impurities.
12. After the self-cleaning process is
completed, put the plug in the wall
socket and let the iron heat up to allow
the Soleplate to dry.
13. Unplug the iron when it has reached the
set ironing temperature.
14. Wipe the hot Soleplate with a piece of
(used) cloth.
15. Rest the iron back on its heel and allow to
fully cool down before storing it.
!
•
Caution
The Soleplate will still be hot, so ensure the
power cord and plug are kept away from it
and the sink.
ANTI-CALCIUM FUNCTION
A special filter inside the Water Tank softens
the water and prevents scale build-up in the
Soleplate. The filter is permanent and does
not need replacement.
ANTI-DRIP FUNCTION
This iron is equipped with a anti-drip function:
the iron will automatically stop steaming
when the temperature is too low in order to
prevent water from dripping out of the
Soleplate. With the anti-drip system, you can
iron even the most delicate of fabrics.
AUTOMATIC SAFETY SHUT-OFF
When the iron is plugged in, the Power
Indicator Light [6] will light steadily, indicating
that the heating element is switched on.
An electronic safety device will automatically
switch the heating element OFF if the iron has
not been moved for more than 30 seconds in
a horizontal position. If in a vertical position
(on its heel rest), this will happen after 8
minutes.
To indicate that the heating element has
been switched OFF, the Auto Shut-Off Light
[8] will start blinking.
i Note
The Auto Shut-Off Light will continue to blink
until the iron is unplugged or reset.
To reset the iron: Move the iron back and
forth. The Auto Shut-Off Light will stop blinking
and the iron will start heating again.
!
• Warning
The auto-off function is a safety feature, not a
recommended way for turning your iron OFF.