Removing The Front Cover - Yamaha NS-333 Manual De Instrucciones

REMOVING THE FRONT COVER

The front cover is fastened to the enclosure at four points
and can be removed if desired. To remove the cover, hold
on to both sides and slowly pull straight away from the
speaker. To reattach, line up the four pegs on the inside
surface of the cover with the four corresponding holes on
the speaker and push gently.
Note
When the cover is removed, take care not to touch the speaker
units with your hands or to exert excessive force with tools.
Information for users on collection and disposal of old equipment:
This symbol on the products, packaging, and/or accompanying documents means that used electrical and
electronic products should not be mixed with general household waste.
For proper treatment, recovery and recycling of old products, please take them to applicable collection points, in
accordance with your national legislation.
By disposing of these products correctly, you will help to save valuable resources and prevent any potential
negative effects on human health and the environment which could otherwise arise from inappropriate waste
handling.
For more information about collection and recycling of old products, please contact your local municipality, your
waste disposal service or the point of sale where you purchased the items.
For business users in the European Union:
If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further
information.
Information on Disposal in other Countries outside the European Union:
This symbol is only valid in the European Union. If you wish to discard these items, please contact your local
authorities or dealer and ask for the correct method of disposal.
SPECIFICATIONS
Type ............................. 2-way bass reflex speaker system
Driver ...........................................13 cm (5") cone woofer
Frequency response.................................. 60 Hz – 35 kHz
Nominal impedance ............................................... 6 ohms
Nominal input power ................................................ 60 W
Maximum input power ........................................... 150 W
Sensitivity ................................................87 dB/2.83 V/m
Crossover frequency ................................................ 3 kHz
Dimensions (W x H x D) ... 200 mm x 320 mm x 213 mm
Weight...............................................5.5 kg (12 lbs. 2 oz.)
• Specifications subject to change without notice due to
product improvements.
• Care should be taken not to exceed the input power
values noted above.
magnetic shielding type
2.5 cm (1") dome tweeter
(7.9"x 12.6" x 8.4")
3