Alarma De Puerta Abierta; Código De Error Y Soluciones - OLSON SBS Serie Manual Del Usuario

9.6Alarma de puerta abierta

Cuando la puerta del refrigerador o del congelador está abierta, se enciende y suena un tono de notificación. Si
la puerta del frigorífico o la puerta del congelador está abierta durante 120 segundos, habrá una alarma sonora,
luego dará la alarma una vez por segundo hasta que se cierre la puerta, o presionar cualquier botón en el panel
de control puede cancelar esta alarma sonora.
Nota: Cuando abra la puerta, el panel de visualización se encenderá. Cuando la puerta está cerrada, el panel de
visualización apague la luz después de 30 s si no hay ninguna operación en el panel de visualización.
9.7 Código de error y soluciones
Nota: mide un código de falla común completo, combinado con la referencia de visualización del producto real.
Error code Fault Type
E0 fault of ice maker
Temperature sensor
E1 fault in refrigerating
chamber
Temperature sensor
E2 fault in freezing
chamber
Temperature sensor
E3 fault in variable
chamber
Defrost sensor fault
in refrigerating
E4
chamber
Defrost sensor fault
E5
in freezing chamber
Communication
E6
failure
Troubleshooting and Solutions
Step 1: Check whether the connection terminals on the ice maker and
the main PCB are plugged in place and whether there are foreign
matters in them; after cleaning the terminals, plug them in again.
Step 2: Enter the forced ice making mode and check whether the ice
maker works normally.
Step 3: If the ice maker does not work, replace the ice motor.
Step 4: If the fault still occurs, replace the main PCB.
Step 1: Check whether the connection terminals are plugged in place
and whether there are foreign matters in them; after cleaning the
terminals, plug them in again.
Step 2: If the fault still occurs, pull out the corresponding connection
Step 3: If the resistance value is wrong, replace the sensor.
Step 4: If the fault still occurs, replace the main PCB.
Step 1: Check whether the connection terminals are plugged in place
and whether there are foreign matters in them; after cleaning the
terminals, plug them in again.
Step 2: If the fault still occurs, pull out the corresponding connection
terminal on the main PCB, use a multimeter to check the resistance
value of the sensor, and confirm whether it is normal.
Step 3: If the resistance value is wrong, replace the sensor.
Step 4: If the fault still occurs, replace the main PCB.
Step 1: Check whether the connection terminal on the display control
panel, hinge cover and main PCB are plugged in place and whether
there are foreign matters in them; after cleaning the terminals, plug
them in again.
Step 2: If the fault still occurs, pull out all connection terminals, use
a multimeter to check the resistance value of the wire between the
display control board and the main PCB to see if it is broken. If test
value is ∞Ω, the wire is broken.(If the wire in the door is broken, replace
the door. Other conditions cannot be repaired.)
Step 3: If the wire is OK, replace the display control board.
Step 4: If the fault still occurs, replace the main PCB.
45