Connections; Connection To Tv; Connection Through Output Of Composite Video (Cvbs); Connection Through Component Video Output (Yprpb) - General Satellite HD 9300 Manual De Instrucciones

1. PrIor To STArTINg THE oPErATIoN
1.5 remote control
27. TV/RADIO
The button is used for switching between the modes of receiving of TV programmes and radio channels.
NOTE!
Design of the remote control can be changed without a prior notification.

2. CoNNECTIoNS

2.1 Connection to TV

2.1.1 Connection through output of composite video (CVBS)

(see 5, pg. 6)
• Connect 2 RCA connectors (red and white) of the cable 3RCA/3RCA to the respectively coloured
output connectors of the audio on the digital Receiver. Connect the 2 RCA connectors at the other end
of the cable to the respectively coloured input connectors of the audio on your TV set.
• Connect the third connector (yellow) of the cable to the VIDEO output of the Receiver, and the
connector at the other end of the cable – to composite video input of your TV set. In case if your TV set
doesn't have 3RCA connectors and only has a SCART connector, then you would have to use a special
SCART-3RCA adaptor.
• Connect coaxial cable of the aerial to the LNB IN connector on the Receiver.

2.1.2 Connection through component video output (YPrPb)

(see 6, pg. 6)
• Connect 3 RCA connectors of the cable 3RCA/3RCA to the respectively coloured VIDEO connectors of
the Receiver, and the connectors at the other end of the cable – to the component video input of your
TV set. In case if your TV set doesn't have 3RCA connectors and only has a SCART connector, then you
would have to use a special SCART-3RCA adaptor.
• Connect 2 RCA connectors (red and white) of the 2RCA/2RCA cable to the respectively coloured audio
outputs on the Receiver. 2 RCA connectors at the other end of the cable should be connected to the
respectively coloured audio inputs on your TV set.
• Connect coaxial cable of the aerial to the LNB IN connector on the Receiver.
61