Assembly Instructions; Legs & Shelf - Pit Boss PB820FBC Instrucciones Y Recetas

ASSEMBLING & MOUNTING
THE LEGS & SHELF
Parts Needed:
2 Legs w/ axels
2 Metal Wheels c/w rubber tire
1 Bottom Shelf
Hardware Required:
Screw 1/4" - 20* 3/5" x20 (AA)
Washer 1/4" x20 (BB)
Spring Washer 1/4" x20 (CC)
Tools Required:
1 - 7/16" Open End Box Wrench
1 - Adjustable Crescent Wrench
or
1 - Phillips Screwdriver
All manuals and user guides at all-guides.com
Installation Steps:
•
•
•
2 Legs for Casters
Note: one of these legs will come with 2 synch nuts installed
into the side of the leg. Ensure this leg is placed on the front
of the grill.
2 Casters
The bottom portion of these two legs, have threaded plate installed
to allow for the two (2) locking casters to be easily installed.
•
•
Note: one of these legs will come with 2 synch nuts installed
into the side of the leg. Ensure this leg is placed on the front
of the grill.
1 INSTALL WHEELS TO LEG ASSEMBLY
Slide metal wheel onto either leg with the axle
Install washer (BB), spring washer (CC), then hand tighten the
screw (AA), onto the threaded axle. Use your wrench to tighten.
Spin each wheel to ensure the wheels turn freely.
2 INSTALL CASTERS TO LEG ASSEMBLY
Hand thread and install the casters on the 2 (two) legs.
Using your wrench turn each of the casters in a clockwise
direction into the bottom leg plate. Turn the casters until
completely in.
7