Troubleshooting - Targa SilverCrest SLM 10 C1 Manual De Instrucciones E Instrucciones De Seguridad

SilverCrest SLM 10 C1
•
Briefly press the on/off button
beep will sound and the power/charge LED (12) will light up blue.
Open the appliance lid (9).
•
Connect the audio device to the AUX IN jack of the speaker. Use
the supplied 3.5 mm jack cable (C).
•
Start the playback on your audio device. Make sure the volume is
set to a low level.
•
Then, adjust the speaker volume to the desired level using the
and (2) buttons. The playback can be muted with the
button.
•
Remove the 3.5 mm jack cable (C) from the AUX IN jack (8) once
AUX IN mode is ended.
•
Close the appliance lid (9).
Do not operate the unit near water when using the AUX IN
connection as it is not splash-proof when the appliance lid
(9) is open.

10. Troubleshooting

The speaker will not switch on
•
The battery of the speaker is empty. Charge the battery with a
suitable USB mains adapter.
Pairing with a compatible Bluetooth
•
Check whether the speaker is switched on. Switch it on, if
necessary.
•
Check the distance between the speaker and Bluetooth
This may not exceed 10 metres. Obstacles and electronic devices
48 - English
(1) to switch the speaker on. A
®
device will not work
(3)
(4)
®
device.