Starting The Charging Process; Completing The Charging Process; Initial Use; Adding Staples - Parkside PAT 4 C3 Traducción Del Manual Original

Starting the charging process

Connect the USB cable
Connect the other end of the USB cable
charging socket
Connect the charger
source. The charge indicator
will light up red whilst charging. Once the battery is fully charged
it lights up green.

Completing the charging process

Disconnect the charger
Disconnect the charger
on the product.
Note: The product cannot be used whilst charging. It is normal
for the handle to warm up slightly whilst charging.

Initial use

Adding Staples

Set the On / Off switch
the product.
Turn the product over.
Squeeze the release button
Pull back on the pusher
Add staples to the magazine
After adding staples, slide the pusher
zine
and lock into place for the magazine
Note: Use the window on the fill indicator
zine
Heruntergeladen von manualslib.de
on the product.
2
7
is fully closed. Release the release button
4
is empty.
4
Handbücher-Suchmachiene
to the charger
7a
to a 100–240 V∼ 50 / 60 Hz power
shows the charging progress. It
9
from the power source.
7
from the micro-USB charging socket
7
to the "0" position before working on
8
(see Fig. A).
3a
(see Fig. A).
3
(see Fig. B).
4
3
4
using the USB socket.
7
to the micro-USB
7a
in again until the maga-
. It must click
3a
to be closed correctly.
to see if the maga-
5
GB/MT
2
87