Recommended cleaning method
– Loosen the dirt:
Spray detergent economically and let it
work for 1...5 minutes but do not let it
dry up.
– Remove the dirt:
Spray off loosened dirt with the high
pressure jet.
After operation with detergent
Set dosing value for detergent to "0".
Open the trigger gun and rinse the de-
vice with the motor running for at least 1
minute.
Interrupting operation
Release the lever on the trigger gun.
Note: When the lever of the hand spray
gun is released, the engine continues to run
at zero speed.
In case of extended interruptions (sev-
eral minutes), switch off the engine.
Activate trigger gun until device is pres-
sure-less.
Secure the hand spray gun using the
safety catch so that it doesn't open ac-
cidentally.
Turn off the appliance
After operating the water using saline water
(sea water), open the hand spray gun and
rinse the appliance for at least 2 - 3 minutes
using tap water.
Close the hand spray gun.
Turn the starter to "0/OFF".
Close fuel cock.
Shut off water supply.
Activate trigger gun until device is pres-
sure-less.
Secure the hand spray gun using the
safety catch so that it doesn't open ac-
cidentally.
Remove the water inlet hose from the
appliance.
22
CAUTION
Risk of personal injury or damage! Mind the
weight of the appliance during transport.
Coil the high-pressure hose and hang it
over the hose storage.
Insert the spray lance into the spray
lance cart.
Place the trigger gun into the holder.
Use the pushing handle to push the ap-
pliance.
When transporting in vehicles, secure the
device according to the guidelines from roll-
ing away, slipping and tipping over.
To reduce the space requirement, loos-
en the star grips and swivel the push
handle backwards.
CAUTION
Risk of personal injury or damage! Consid-
er the weight of the appliance when storing
it.
This appliance must only be stored in inte-
rior rooms.
Frost protection
ATTENTION
Risk of damage! Freezing water in the ap-
pliance can destroy parts of the appliance.
In the winter, preferably store the device in
a heated room
If storing it in unheated rooms, follow these
instructions:
Drain water
Screw off water supply hose and high
pressure hose.
Operate device for max. 1 minute until
the pump and conduits are empty.
Unscrew the water filter and empty it.
Flush device with anti-freeze agent
Note: Observe handling instructions of the
anti-freeze agent manufacturer.
Pump in conventional frost protection
agents through the appliance.
A certain corrosion protection is achieved
with this as well.
EN
– 7
Transport
Storage