Fan Assembly. Pgs - Craftmade ELLINGTON LAR54CH3 Guia De Instalacion

5. Fan Assembly
If you wish to extend the hanging length of your fan,
you must remove the hanging ball from the downrod
provided to use with an extended downrod (sold
separately). [If you wish to use the downrod provided,
please proceed to instructions following the dotted line
below.]
To remove hanging ball, loosen set screw on hanging
ball, lower hanging ball and remove stop pin. Slide
hanging ball off the original downrod, A, and slide it
down the longer downrod, B (the top of the downrod
should be noted as having a set screw hole; use this
hole when setting the set screw). Insert stop pin into
top of extended downrod and raise hanging ball. Be
sure stop pin aligns with slots on the inside of the
hanging ball. Tighten set screw securely.
Tip: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the
ends of the electrical wires--this will keep the wires
together when threading them through the
downrod.
Locate canopy cover in hardware pack. Loosen yoke
set screws and nuts at top of motor housing. Remove
pin and clip from motor housing yoke. Slide
downrod through canopy, canopy cover and yoke
cover. [Note: Canopy cover must be turned with
shiny side toward the motor.]
Thread safety cable and electrical wires through
downrod and pull extra wire slack from the upper
end of the downrod.
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert pin
and clip that were previously removed. Tighten yoke
set screws and nut securely. Lower yoke cover to
motor housing.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
set screw
A
electrical wiring
canopy
yoke cover
pin
page 4
set screw hole
stop pin
hanging ball
B
safety cable
downrod
canopy cover
yoke set screw
motor
housing
clip