Blade Assembly - Craftmade ELLINGTON LAR54CH3 Guia De Instalacion

8. Blade Assembly.

Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 9 blade attachment screws and
washers and 9 decoratvie nuts in one of the
hardware packs. Place blade on BOTTOMSIDE
of blade arm, aligning holes in blade arm
with holes in blade as shown. Insert 3
decoratvie nuts into holes from UNDERSIDE of
blade (i.e., the side that will face the floor),
making sure to completely insert each
decorative nut so that the blade arm and
blade can be attached correctly. Insert 3
attachment screws (along with washers) from
TOPSIDE of blade arm with fingers first and
then tighten screws securely with Phillips
screwdriver. Repeat procedure for remaining
blades.
Note: Tighten blade arm screws twice a year.
motor
housing
page 7
blade attachment
screws and washers
blade arm
blade
decorative
nuts