Light Kit Assembly. Pgs; Important - Craftmade ELLINGTON LAR54CH3 Guia De Instalacion

9. Light Kit Assembly.
Remove 1 screw on motor plate (on underside of
motor assembly) and loosen the other 2 screws.
Align slotted holes in center of the fitter plate
with loosened screws on motor plate, allowing
the molex connections from motor assembly to
come through hole in middle of fitter plate. Twist
fitter plate to lock. Re-insert screw that was
previously removed and securely tighten all 3
screws with Phillips screwdriver.
Connect WHITE wire from motor assembly to
WHITE wire from light kit fitter. Connect BLACK
wire from motor assembly to BLACK (or BLUE)
wire from light kit fitter. Make sure that molex
connections are secure.
Remove 3 screws from outer edge of fitter plate.
Align holes in light kit fitter with holes in fitter
plate. Re-insert screws that were just removed
and securely tighten all 3 screws with Phillips
screwdriver.
Install 1 candelabra base bulb 60 watt max.
(included).
IMPORTANT: When replacing bulbs, please allow
bulb(s) and glass shade to cool down before
touching them.
fitter plate
fitter
plate
light kit fitter
bulb
page 8
motor housing
motor plate
molex
connections