4-2.DAta; 4-2-1.TEsting A Data Patch Cable Terminated With Rj45 Connectors - Temper KCM-RJ-0767493 Instrucciones De Operación

VDV Wire Tester

4-2.Data

WARNING: Exposure to voltage can damage the tester. Immediately disconnect the cable under
test if the Voltage warning appears on the display. Make sure the cable is not connected to any
device that can supply voltage before retesting. Do not connect two different cables into the Voice
(RJ11/RJ12) and Data (Rj45) test ports at the same time. The cables will interact with each other
and alter test results.

4-2-1.Testing a Data Patch Cable Terminated with RJ45 Connectors

1.Press ON/OFF Button to turn on the tester and then press Data Button to select the
data wire test function.
2.Connect one end the cable under test to the RJ45 port on the tester.
3.Connect the other end of the cable under test to the RJ45 port on the remote.
4.Interpret the results using the wiring and display examples on page 14.
Remote
13