4-2-2.TEsting An Installed Data Cable - Temper KCM-RJ-0767493 Instrucciones De Operación

VDV Wire Tester

4-2-2.Testing an Installed Data Cable

1.Connect a known good patch cable to the wall port or patch panel of the cable being tested.
2.Connect the other end of the patch cable to the RJ45 port on the tester.
3.Connect another known good patch cable to the RJ45 port on the remote.
4.Connect the other end of the patch cable to the wall port or patch panel at the other end of the
cable being tested.
5.Press ON/OFF Button to turn on the tester and then press Data
data wire test function.
6.Interpret the results of the test using the display and wiring examples shown on page 19 and 20.
14
Patch Panel
Patch Cable
Button to select the
Remote