Adjusting The Sound Characteristics; Attenuating The Sound; Changing The Sound And Display Settings - Sony XR-C8100R Manual De Instrucciones

Adjusting the sound
characteristics
You can adjust the bass, treble, balance and
fader.
Each source can store the bass and treble levels
respectively.
1
Select the item you want to adjust by
pressing (SOUND) repeatedly.
VOL (volume) n SUB (subwoofer volume)
n BAS (bass) n TRE (treble)
n BAL (left-right) n FAD (front-rear)
2
Adjust the selected item by rotating the
dial.
Adjust within three seconds after selecting
the item. (After three seconds, the dial
functions as the volume control.)
EN

Attenuating the sound

Press (ATT) on the rotary commander or
wireless remote.
"ATT on" flashes momentarily.
To restore the previous volume level, press
(ATT) again.
Tip
The unit decreases the volume automatically when
a telephone call comes in (Telephone ATT
function).
20
Changing the sound and
display settings
You can set:
•Clock (page 7).
•CT (Clock Time) (page 18).
•D.Info (Dual Information) to display the
clock and the play mode at the same time
(ON) or to display the information
alternately (OFF).
•Amber/Green to change the illumination
colour to amber or green.
•Dimmer to change the brightness of the
display.
— Select "Auto" to dim the display only
when you turn the lights on.
— Select "on" to dim the display.
•Contrast to adjust the contrast if the
indications in the display are not
recognizable because of the unit's installed
position.
•Voice guide function for vocalized comments.
•Beep to turn on or off the beeps.
•RM (Rotary Commander) to change the
operative direction of the controls of the
rotary commander.
— Select "norm" to use the rotary
commander as the factory-set position.
— Select "rev" when you mount the rotary
commander on the right side of the
steering column.
•Loud (Loudness) to enjoy bass and treble
even at low volume. The bass and treble will
be reinforced.
•LPF (Low Pass Filter).
•A. Scrl (Auto Scroll) (page 22).
1
Press (SHIFT).
2
Press (3) (SET UP) repeatedly until the
desired item appears.
Each time you press (3) (SET UP), the item
changes as follows:
Clock n CT n D.Info* n Amber/Green n
Dimmer n Contrast n Voice* n Beep n RM
n Loud* n LPF* n A.Scrl*
* When the radio is off, or when there is no
tape, CD, or MD being played, these items
will not appears
Note
The displayed item will differ depending on
the source.