Dremel 4000 Instrucciones De Funcionamiento Y Seguridad página 14

DM 2610016589 05-12_DM 2610016589 05-12.qxp 6/26/12 2:12 PM Page 14
BEARINGS
Model 4000 has ball bearing construction.
Under normal use no additional lubrication is
required.
Cleaning
To avoid accidents always
WARNING
disconnect the tool from
the power supply before cleaning or
performing any maintenance. The tool may
be cleaned most effectively with compressed
dry air. Always wear safety goggles when
cleaning tools with compressed air.
Extension Cords
If an extension cord is necessary, a cord
with adequate size conductors that is
capable of carrying the current necessary
for your tool must be used. This will prevent
excessive voltage drop, loss of power or
overheating. Grounded tools must use 3-wire
extension cords that have 3-prong plugs and
receptacles.
NOTE: The smaller the gauge number, the
heavier the cord.
Use only Dremel
WARNING
designed for this tool and may lead to personal injury or property damage.
The number and variety of accessories for the
Rotary Tool are almost limitless. There is a
category suited to almost any job you might
have to do — and a variety of sizes and shapes
within each category which enables you to get
the perfect accessory for every need.
If you expect to use a variety of accessories,
we recommend that in the beginning you
purchase a complete set of four collets. Store
these so that you will have the proper size of
collet for any accessory or drill bit you want to
Dremel Accessories
®
, high-performance accessories. Other accessories are not
Collets
Ventilation openings and switch levers must be
kept clean and free of foreign matter. Do not
attempt to clean by inserting pointed objects
through openings.
Certain cleaning agents
CAUTION
and
plastic parts. Some of these are: gasoline,
carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents
that contain ammonia.
RECOMMENDED SIZES OF EXTENSION CORDS
120 VOLT ALTERNATING CURRENT TOOLS
Cord Size in A.W.G.
Tool's
Ampere
Cord Length in Feet
Rating
25 50 100 150
3-6 18 16 16
6-8 18 16 14
8-10 18 16 14
10-12
16 16 14
12-16 14 12 —
use. Currently, the 1/8", 3/32",1/32" and
1/16" collets accommodate all of the avail -
able Dremel accessories. 1/8" collets are
included in most rotary tool kits.
Mandrels
A mandrel is a shank with a threaded or screw
head, which are required when you use
polishing accessories, cutting wheels, sanding
discs, and polishing points. The reason
mandrels are used is that sanding discs,
cutting wheels and similar accessories must be
replaced frequently. The mandrel is a per-
manent shank, allowing you to replace only the
worn head when necessary, thus saving the
expense of replacing the shaft each time.
14
solvents damage
Wire Sizes in mm 2
Cord Length in Meters
15 30 60 120
14 0.75 0.75 1.5 2.5
12 0.75 1.0 2.5 4.0
12 0.75 1.0 2.5 4.0
12 1.0 2.5 4.0 —
— — — — —